The guides weren't the fix. It was the right side flap arm motor according to the dealer. Guess we will find out once they get the part on. If I believed that we could fix it here without tearing something up then I would definately do it. The only reason we had this was because its the bosses grand...

Tried the reset. Doesnt help. Check the circuit breakers they are okay.Finally got ahold of a contact at dealer here and they said they have had problem with guides breaking and causing the binding. Guess we will ship it to dealer. Thanks for all the ideas.

We have run into a stopping point on this car. It will only open about 3/4 way then will shut down. Once system reset you can close but still will not open all the way. iIt is tripping the circuit breaker. Our scanner that should be able to read this vehicle according to Snap-on wont communicate wit...

From what we saw it looked like they sand blasted the head and then painted. Once we started the engine 2 of the cylinders intake valves jammed up with the aluminum and sand material and some must have went down into the cylinders. Which is what we figured happened but they told us that it was just ...

Will definately look for Alabama next time. We sent engine to machine shop and found the debris did wash out the rings and pistons. That's okay our vendor is taking care of that bill and hashing it out with their guy.

Well we have come to the conclusion with our vendor that the debris that they said would not hurt the rings actually did. Not only that but the 2nd head they rebuilt and sent to us was our old head that was leaking water into the cylinder.. Never again will we go that route... So now we are trying t...

This is the head without cam sensor. Has hole with plug. Noticed new issue today. We got correct info for timing from Isuzu and set. Used new timing belt. Vehicle started without valve cover on. Put cover on and hooked all up and now won't start again.... We are tearing it back down once again...

Have gone over this many time.Even had some of my other techs relook to make sure all is connected. Head was ordered from local parts house not from Isuzu. We have triple checked the cams and all is right according to the manual. We had to change the LH side from the way it was set when it was rebui...

Vehicle came in with #6 cylinder leaking water into spark plug tube. Removed heads; had right side cleaned and machined. Purchased reman left head. Installed and engine wouldn't run. Pulled head and found soot and debris in #4 & #6 intake valves from head. Ordered new head. Installed new head. Reset...