Thanks. We had already tried to reset. We had a defective sensor wire that wouldn't it to reset.

Brake light on dash is illuminated and replace front brake pads message is showing. Front pads and sensors were replaced, but cannot get the light and message to reset.
Help would be appreciated. Thanks

Engine stalls but will restart immediately. Has strong fire and good fuel pressure. There are no DTCs. Will run a short time (no more than a minute) before stalling again. Any suggestions would be appreciated. Thanks

Here are the pics.

THE MISSING part is the air diverter rotator in the front of the intake. Ad seen in pics. Hope it helps!

Have a 2006 C230 that has an insert missing that covers a hole in the front of the intake. The insert controls the flappers inside the intake. Trying to find out what this part is called. We know the intake will have to be removed to replace it, just don't see any info in the repair manual. Thanks

No new cam. All original type parts. Let me redescribe the problem, instead of loping it's more a rough idle and erratic idle only when in drive or reverse. It's fine in park or nuetral and runs great once you give it gas and are moving. When you come to a stop or are turning the roughness re-appear...

This engine has a new carburetor and distibutor and it's been tuned up. It runs great going down the road but has a rough idle and the engine lopes at idle. We've checked timing and it's dead on. Not sure where else to look.

Any suggestions?

MANUAL TRANSMISSION WILL NOT SHIFT GEARS UNLESS ENGINE IS NOT RUNNING. WILL SHIFT INTO ANY GEAR AS LONG AS ENGINE IS OFF. IT PULLS IN ANY GEAR JUST WILL NOT SHIFT. IDEAS ON WHERE TO START.

Engine mounts are good and no misfires on the counter

Truck has 66k miles. Starts fine and idles fine until the engine gets warm and then you can feel a tremble in the seat. It also does this at approx. 45 to 50 mph after its warm. Dealership has cleaned the air intake system and reprogrammed the computer and there are no codes stored. Open to suggesti...

Changing oil on 2008 E320 diesel and cannot find what proper weight of oil to put in. Any help would be appreciated.

NO IGNITION FIRE.

TRYING TO ACCESS ECM BUT KEEP GETTING AN ERROR MESSAGE ON SCAN TOOL. THINKING MAY HAVE A BAD ECM.

ANY IDEAS? THANKS

TRYING TO REPLACE DRIVER'S SIDE CV AXLE. CANNOT GET IT TO COME OUT. HAVE EVEN TRIED TAKING OUT PASSENGER SIDE AXLE AND KNOCKING IT OUT FROM THE PASSENGER SIDE. WHAT'S ANOTHER OPTION?

This car will not start after it sits for an hour to an hour and a half. It will spin over and over. The warmer the temp is outside the longer it takes to start. Starts perfectly every morning and after sitting long enough during the day. The check engine light is not on, it has plenty of fuel press...

CHECKED CHARGING SYSTEM. REPLACED BATTERY, ALTERNATOR GOOD. CAR RUNS GOOD. EVERTHING ELSE IS NORMAL

Will not start for 30 minutes to 50 minutes after engine has been turned off for 30 minutes to an hour. This condition is intermitent. Sometimes it starts fine after sitting for a short time. Has spark and fuel pressure and at some point during the no start if you turn the starter over it will for a...

THANKS FOR THE HELP. WE ARE GOING TO TRY ANOTHER PUMP

REGULATOR IS ON TOP OF THE FUEL PUMP MODULE. BEEN OUR EXPERIENCE THAT A BAD REGULATOR WOULD CAUSE PRESSURE TO BE TOO HIGH.

PRESSURE DOES STAY AT 25PSI FOR AT LEAST 10 MINS. ONCE IT STARTS IT RUNS FINE UNTIL YOU CUT THE ENGINE OFF AND LEAVE IT AND THEN RESTART LATER.