Search found 28 matches

by nokomisauto
Wed Jan 18, 2017 10:56 am
Forum: Ford Trucks
Topic: 2011 Ford E350 5.4L - Hard Starting When Cold
Replies: 4
Views: 3202

Re: 2011 Ford E350 5.4 Hard starting when cold

The alcohol test is 15% alcohol in gas. It blows black smoke when it starts when it not starting its has spark . But on the scan tool show in one of pids is showwing 51.4 % alcohol. this van has new factory cat and o2sensors do too someone steeling cats on our town last summer.
by nokomisauto
Wed Jan 18, 2017 6:44 am
Forum: Ford Trucks
Topic: 2011 Ford E350 5.4L - Hard Starting When Cold
Replies: 4
Views: 3202

2011 Ford E350 5.4L - Hard Starting When Cold

I have 2011 Ford E350 Van 5.4 L with 68000 miles this van can to my shop with starting problem I found when the outside at temps of 10 above or below zero this van will turn over but will not fire I found if i hold throttle about half way down it may start at times most of the time it floods out rig...
by nokomisauto
Thu May 21, 2015 1:58 pm
Forum: Dodge Trucks / Jeep
Topic: 2006 Jeep Wrangler sport 4.0 std trans 4x4 p2302,p2305
Replies: 5
Views: 3629

Re: 2006 Jeep Wrangler sport 4.0 std trans 4x4 p2302,p2305

Up date on jeep found problem in oil pump drive it lock up for one sec and started turning after it turn housing a 1/4 turn and tack it out syn repair oil pump drive and now it runs
by nokomisauto
Wed May 20, 2015 12:43 pm
Forum: Dodge Trucks / Jeep
Topic: 2006 Jeep Wrangler sport 4.0 std trans 4x4 p2302,p2305
Replies: 5
Views: 3629

2006 Jeep Wrangler sport 4.0 std trans 4x4 p2302,p2305

This jeep is driving nuts I put new champion plugs # 438 .035 plug gap and replace coil pack and engine stills runs ruff and code come back we remove fuel injectors and test injector spray pattern and fire very good pattern replace crank and cam sensor and IGNITION CAPACITOR and still works the same...
by nokomisauto
Wed Jan 22, 2014 7:50 am
Forum: Toyota / Lexus
Topic: 2013 Toyota CamryHybrid - ABS Problem
Replies: 3
Views: 3870

Re: 2013 Toyota CamryHybrid abs problem

The wiring harness was replace with new harness and all new fuse block with fuse from Toyota I do think that motor went out I ordered part.
Thank you for input.
by nokomisauto
Tue Jan 21, 2014 2:55 pm
Forum: Toyota / Lexus
Topic: 2013 Toyota CamryHybrid - ABS Problem
Replies: 3
Views: 3870

2013 Toyota CamryHybrid - ABS Problem

2013 Toyota Camry Hybrid xle car was a front end hit and it was hard. Abs light is on . I found codes of c1252 and c1253 and c1256 we check ground foe boost pump and powers and have 12.52 volts at wire when applying brake pedal and that is when 12.52 volts come to boost pump motor to turn on pump th...
by nokomisauto
Fri Nov 15, 2013 7:56 am
Forum: Dodge Trucks / Jeep
Topic: 2003 Jeep Liberty 3.7 Head Lights problem
Replies: 3
Views: 2740

Re: 2003 Jeep Liberty 3.7 Head Lights problem

bcm code headlamp switch input circurt high is the code Head lamp switch did not past ohm test when I replace a year ago Relays that II replace because the switch past the ohm test and only has 4000 miles on new switch just can see that the switch is bad at this time so then I replace the relays bec...
by nokomisauto
Fri Nov 15, 2013 5:53 am
Forum: Dodge Trucks / Jeep
Topic: 2003 Jeep Liberty 3.7 Head Lights problem
Replies: 3
Views: 2740

2003 Jeep Liberty 3.7 Head Lights problem

2003 Jeep Liberty Limited 3.7 4x4 with 148248 Miles It came in a year ago with no head lights check body computer and code of head lamp switch input malfunction found problem in combo switch replace switch fix problem. then its back in my shop with head lights not working and pulled codes out bcm fo...
by nokomisauto
Mon Jul 16, 2012 9:48 am
Forum: Dodge Trucks / Jeep
Topic: 1998 Chrysler Town & Country - 3.3L P1695
Replies: 3
Views: 2680

1998 Chrysler Town & Country - 3.3L P1695

Dealing with p1695 code This has ccd system @ 16 Pin dcl, pin 3 has 2.1 volts and pin 11 has 2.2 volts. Thats with body computer unpluged; that will be right with data wires in that plug but I can not talk to other computers and cluster will not light up. Put new board for dealer and still wont ligh...
by nokomisauto
Thu Mar 29, 2012 4:17 am
Forum: Toyota / Lexus
Topic: 2002 Lexus RX300 AWD - Ratcheting Noise?
Replies: 6
Views: 4430

Re: 2002 Lexus RX300 AWD - Ratcheting Noise?

The customer and I talked about it and he ask me to pull t case out see if we came find problem. When and if the noise comes in It sounds like splines slipping. I will post what the fix or what I found next week thank you for the input.
by nokomisauto
Wed Mar 28, 2012 6:59 am
Forum: Toyota / Lexus
Topic: 2002 Lexus RX300 AWD - Ratcheting Noise?
Replies: 6
Views: 4430

2002 Lexus RX300 AWD - Ratcheting Noise?

Customer is complaining of a ratcheting sound after making a complete stop and rolling forward slowly it will make a quick ratcheting sound - very intermittent noise. We found bulletin dealing with the ABS sensors and wheel bearings. We did that repair as per the bulletin. Problem is still there. We...
by nokomisauto
Tue Jan 03, 2012 3:21 pm
Forum: Imports - Other
Topic: 2004 Hyundai Sonata - 2.4L Front Balance Shaft Timing
Replies: 2
Views: 2672

2004 Hyundai Sonata - 2.4L Front Balance Shaft Timing

2004 Hyundai Sonata dohc 2.4L We did a valve job and new timming belts aligned all markes by repair manul and gave back to owner and can back for vibration and loud noise retime front shaft and 8mm x60mm bolt to align front balance shaft and replace tensor with new tensor gave back to owner can back...
by nokomisauto
Wed Sep 07, 2011 4:19 am
Forum: Dodge Cars
Topic: 2007 Dodge Caliber SXT - 2.0L CVT Trans Calibration
Replies: 1
Views: 2689

2007 Dodge Caliber SXT - 2.0L CVT Trans Calibration

I have 2007 Dodge Caliber sxt with 2.0 cvt trans I just put a new trans in. Got the trans from mopar, got car up and running and found code p167a for Calibration mismatch and went diag chart found that it has to be calibration needs to be done. I have Snap-on Verus and found no way to do it unless y...
by nokomisauto
Thu Aug 25, 2011 6:22 am
Forum: Ford Cars
Topic: 1996 Lincoln Town Car - 4.6L P0174 Lean Bank #2-Fixed
Replies: 5
Views: 3688

Re: 1996 Lincoln Town Car - 4.6L P0174 Lean Bank #2

The fix was the mass air flow sensor Thank You for your help. Ray
by nokomisauto
Mon Aug 08, 2011 7:09 am
Forum: Ford Cars
Topic: 1996 Lincoln Town Car - 4.6L P0174 Lean Bank #2-Fixed
Replies: 5
Views: 3688

1996 Lincoln Town Car - 4.6L P0174 Lean Bank #2-Fixed

We have 1996 Lincoln Town Car with 4.6 Engine. Code p0174 both fuel trims at idle are moving 3+ to 3- on both banks. When driving, it jumps on both banks to 30 to 40+ trims. We check for vaccum leaks with propane and egr tube and clean mass air flow sensor; readings are in spec by ford specs. The o2...
by nokomisauto
Tue Mar 08, 2011 3:40 pm
Forum: Dodge Trucks / Jeep
Topic: 2001 Dodge Grand Caravan - Running Very Rich
Replies: 7
Views: 3372

Re: 2001 Dodge Grand Caravan - Running Very Rich

Thanks for the help it was up stream o 2 sensor replace o2sensor and change oil and filter and fuel trims came back and flooding stopped.

Thank You
Too all imputed on this problem.
by nokomisauto
Tue Mar 08, 2011 7:07 am
Forum: Dodge Trucks / Jeep
Topic: 2001 Dodge Grand Caravan - Running Very Rich
Replies: 7
Views: 3372

Re: 2001 Dodge Grand Caravan - Running Very Rich

Short trims at 24.5 postive
Long trims at 0 because its not running very long
by nokomisauto
Tue Mar 08, 2011 6:55 am
Forum: Dodge Trucks / Jeep
Topic: 2001 Dodge Grand Caravan - Running Very Rich
Replies: 7
Views: 3372

2001 Dodge Grand Caravan - Running Very Rich

2001 Dodge Grand Caravan Sport Van Came in flooding and hard starting and black smoke out tail pipe Test computer no codes Fuel presure 58 lbs at idle Vacum at idle with engine flooding 15 in and map reads the same Coolant temp reading shop temp at 70 Air temp at 70 plug off both evap vacum hoses pl...

Go to advanced search