How do you enter multiple P#### codes?
Posted: Tue May 10, 2016 12:31 pm
Back a few Snap on scanners ago the Tech could send a list of codes to a file on my system. It was awesome, I just opened file, copy them and pasted them to the RO. Took a few seconds. Some how we lost that ability. (IT guy says its Snap ons Fault) So now the techs write them all down and bring them to me. And I have to type them all in.
I have been messing around trying to figure out a quick and slick way to do this using the Mitchell system. I went into "jobs" and made up a few to test. But if I have 10 codes, it takes up ten line on the Screen. It is easy this way, however adds lots of clutter.
How do you guys do it?
I have been messing around trying to figure out a quick and slick way to do this using the Mitchell system. I went into "jobs" and made up a few to test. But if I have 10 codes, it takes up ten line on the Screen. It is easy this way, however adds lots of clutter.
How do you guys do it?