Page 1 of 1
2003 GMC Yukon - Brake Line Identification
Posted: Tue Jul 02, 2019 8:39 am
by nickscarcare
1GKFK66U73J313325 I am trying to find a diagram of the abs module that shows where the brake lines go to. All I can find is ones with only 5 ports at the module, and the Yukon has 6 ports, one line for each rear brake. It is near impossible to try to trace these things without dropping the fuel tank.
Re: 03 GMC Yukon brake line identification
Posted: Tue Jul 02, 2019 9:30 am
by Rich
I just looked, all we have is the 5 line diagram. Sorry
Re: 03 GMC Yukon brake line identification
Posted: Tue Jul 02, 2019 10:04 am
by nickscarcare
Yep and that is all I have.
Re: 03 GMC Yukon brake line identification
Posted: Tue Jul 02, 2019 10:16 am
by JBUTITTA
The line id should be etched into the ebcm next to the proper port. its not a deep etching so it maybe hard to see but if its oe it shoulb be there. hth. Jerry
Re: 03 GMC Yukon brake line identification
Posted: Tue Jul 02, 2019 10:17 am
by Rich
Re: 03 GMC Yukon brake line identification
Posted: Tue Jul 02, 2019 10:36 am
by nickscarcare
Jerry, in the rust belt here anything is near impossible to read. Rich, no that one is not correct either, I did find that one.
Re: 2003 GMC Yukon - Brake Line Identification
Posted: Tue Jul 09, 2019 4:49 am
by nickscarcare
Is there any way the folks at Mitchell can see if there is a look up for this? Or just forget it?
Re: 2003 GMC Yukon - Brake Line Identification
Posted: Tue Jul 09, 2019 5:12 am
by ricmorin
nickscarcare wrote:Is there any way the folks at Mitchell can see if there is a look up for this? Or just forget it?
The quickest route is to just give a call to support.
Re: 2003 GMC Yukon - Brake Line Identification
Posted: Tue Jul 09, 2019 7:20 am
by LazyTurtle
Spoke with the experts here and they gave me this info:
There is a TSB that has a year range from 1999 thru 2007 for this very thing - in 1Search, type in Brake Line, click on TSB Button, Anti-Lock Brakes - TSB Number 13-05-22-001D
If you can't find what you are looking for within 5 minutes of searching, the wrenches here suggest calling in (option 3).
Re: 2003 GMC Yukon - Brake Line Identification
Posted: Wed Jul 10, 2019 4:59 am
by nickscarcare
Lazy Turtle, again that is for a 5 port system, I need 6. I can't imagine it is that much of an oddball, but it must be.
Re: 2003 GMC Yukon - Brake Line Identification
Posted: Wed Jul 10, 2019 7:20 am
by ricmorin
nickscarcare wrote:Lazy Turtle, again that is for a 5 port system, I need 6. I can't imagine it is that much of an oddball, but it must be.
I don't think you read the entire bulletin. Keep scrolling and you'll see the diagram that contains the 6 port system.
- 6 port.png (25.79 KiB) Viewed 7462 times
Re: 2003 GMC Yukon - Brake Line Identification
Posted: Wed Jul 10, 2019 8:20 am
by Rich
https://static.nhtsa.gov/odi/tsbs/2014/ ... 1-7817.pdf
Page 16 !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Thanks for the info Ric!
Re: 2003 GMC Yukon - Brake Line Identification
Posted: Thu Jul 11, 2019 5:06 am
by nickscarcare
Ha I just went back and looked again, and I only get 8 pages of that TSB. I went in through a different source and yes it pulls all of it. Great technology when it don't load all the pages.
Re: 2003 GMC Yukon - Brake Line Identification
Posted: Thu Jul 11, 2019 5:09 am
by nickscarcare
I was just trying to figure out how to get the picture resized, to load it on here. That is what I came up with after trial and error of blowing air through one line with the ends cut off. I figured there had to be a diagram somewhere.
Re: 2003 GMC Yukon - Brake Line Identification
Posted: Thu Jul 11, 2019 5:10 am
by nickscarcare
Thanks for the info though and hopefully it helps someone else.