Jump From Manager To Catalog
Jump From Manager To Catalog
The old version would allow us put parts on order form a vendor catalog and then jump to Mitchell and then go back to the same catalog without losing any info. Now if you want to jump back to Mitchell you have to start all over in the catalog. Is there a fix for this?
-
timbre4
- System Guru / Moderator
- Posts: 4536
- Joined: Tue May 25, 2004 5:47 pm
- Location: TN - Volunteer State
Re: Jump From Manager To Catalog
Welcome to the forum and thanks for your post.
I will assume that you are referring to Manager 5.9.x then and SE 6.4 now? To assist you I need to know the following:
1. Which parts catalog were you using?
2. Which vehicle were you looking up parts for?
3. Was the vehicle fully qualified? (not just YMM but also body style and engine)
4. What information do you see as not retained?
I will assume that you are referring to Manager 5.9.x then and SE 6.4 now? To assist you I need to know the following:
1. Which parts catalog were you using?
2. Which vehicle were you looking up parts for?
3. Was the vehicle fully qualified? (not just YMM but also body style and engine)
4. What information do you see as not retained?
Tim McDonnell -
Sr. Product Market Mgr / Forum Moderator / Mitchell 1 Media Developer
Sr. Product Market Mgr / Forum Moderator / Mitchell 1 Media Developer